NC Angler Forums banner
mount
1-5 of 5 Results
  1. The Boating Forum
    My trolling motor mount keeps coming lose. The previous owner drilled 1/2" diameter holes in the bow of the boat. The Minn Kota trolling motor uses 1/4" bolts for mounting. The play in the size difference is causing my trolling motor to move around a lot more than it should. I used SS bolts...
  2. The Boating Forum
    I had an older transducer bracket on my boat where there original one was when I bought it. The new bracket for the Lowrance elite 7ti is larger than expected and will not fit in the groove where the old bracket was mounted(it would hang beneath the boat), the only location I see it fitting to...
  3. The Boating Forum
    I made a mount for my spare yesterday because I got tired of having to grab it when I took the boat out and I didn't want to take up floor space in the boat with it if I were to just leave it in the boat. I thought about copying the type you can buy that mounts it to the side of the tongue of...
  4. Gear and Tackle
    Any suggestions for a good but temporary transducer mount to a pontoon. My transducer has a suction cup but I question how well it will hold to the back of the pontoon at any speed and not sure if I can get it far enough into the water that way. I was thinking about attaching the transducer...
  5. The Boating Forum
    Ok, I'm a boating newbie. I just bought my very first boat and am looking to set it up a little so I can do some fishing with my wife. The boat is a 12' Tracker Topper jon boat. I've done some research and think I've settled on the Driftmaster rod holders, but can't seem to figure out how most...
1-5 of 5 Results
Top