NC Angler Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
Just finished working on an old tin boat. Took about 7 months due mostly to limited cash flow. Replaced all the wood, added seats and slides, 1/4" rubber matting on floor, anchor guides (fore and aft),rod holders for fly rods, bow storage and motor tune up. Also total refurb on trailer.
Taking her out for first fishing trip tomorrow.
All comments welcome and thanks for looking,
Mike
 

Attachments

1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top