NC Angler Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,652 Posts
Discussion Starter · #1 ·
Was weird. My yak FF worked fine last weekend. I went out Friday and my FF was not working. Discovered a blown fuse. New fuse went phfst. Disconnected the wiring and still metered short. Cut the cable to narrow it down. Cut it again and the short was gone.

The section removed was a coil block that was inline.

Anyone ever have an issue with those things?? It was molded in. Not one of the wrap around ones.

mike
 

·
Registered
Joined
·
1,652 Posts
Discussion Starter · #4 ·
Ya, i believe it's there for that. Seeing as it's in my yak.... The only ignition noise is me.

But usually, it's just around the wires and not an integral part of it. I can see them making it part of the wire insulation. No need for it to slide on the wire. But it still should not be contacting any wires.

And the unit worked just fine without it.

mike
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top