NC Angler Forums banner

Rod Holder for shore fishing

3395 Views 0 Replies 1 Participant Last post by  Coach D
Easy and not that expensive to make. I took a piece of pvc pipe cut around 8 inches long from the discard pile at a construction site. These already had caps on them but caps are easily bought at any home improvement store. I then cut a hole in the cap about the same size as a Tent spike. When I got to where I wanted to fish I stuck the tent spike in the ground and pulled it out to make a hole. Then I took the spike I used to make the hole put it in the hole in the cap of the pvc pipe and using a stick or the handle of a hammer I pushed it on down inside the hole. Held my rod perfect for about 5 hours yesterday. Hope this is useful.
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top