NC Angler Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter · #1 ·
I have a 16ft Lowe Big Jon boat. It has the oar mounts on each side. I was wondering if anyone knows if they make a rod holder that will fit in the oar mount? That would be awesome, because I have no plans whatsoever to put oar swivels in there and row that boat!!! To old for that crap.:)
 

·
Registered
Joined
·
64 Posts
Discussion Starter · #3 ·
backlash..you are the man!!. I have looked all over for something like this. Want to put some rod holders on the boat and have alway figured that was the best place for them since it is only wasted space. I don't know how you found them so fast, but thanks a million!
 

·
Registered
Joined
·
80 Posts
ok you can go to wal-mart and get rod holders and then get a flat piece of iron like a old bed frame make a t one big bolt that will slide 180 degrees i have 20 rod holders and you can even make 1 5/16 pipe use with 2 inch pipe all you have to do to get your rod out is just lift up killer catfish set up
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top